Frigidaire FFEF4015LW Manual Do Utilizador

24

Be sure the range is cool before removing elements or 

drip bowls. Be careful not to bend terminal ends when 

replacing elements after cleaning.

When lowering the lift-up range top, grasp the sides 

with fi nger-tips only. Be careful not to pinch fi ngers. 

DO NOT drop or bend the range top when raising or 

lowering. This could damage the surface.

Surface elements can be unplugged and removed to 

make cleaning the drip pans easier. The surface elements 

clean themselves when they are turned on. Food 

spilled on a hot element will burn off. Food spilled on a 

cool element may be cleaned with a damp cloth—any 

remaining soil will burn off the next time the element is 

used. Never immerse a surface element in water.
To Remove the Surface Elements and Drip Bowls

1.  Lift up edge of surface element across from terminal 

end. Lift just enough to clear edge of the drip bowl. 

2.  Gently slide the surface element out of the terminal 

plug. 

3.  Lift the drip bowl up and out.

Wash in hot, soapy water or in the dishwasher. Rinse 

and dry while still warm. Hard to remove, burned on soil 

can be removed by soaking the drip bowls for about 20 

minutes in a lightly diluted liquid cleanser or a solution 

of ammonia and water (1/2 cup ammonia to 1 gallon 

of water). A nylon scrubber may be used after soaking. 

DO NOT use abrasive cleaners or steel wool, as they will 

scratch the surface. Always rinse with clean water and 

polish dry with a soft cloth.

To Replace Drip Bowls and Surface Elements  

1.  Slide the terminal end on the element through the 

opening in the drip bowl.

2.  Align the element support to rest on the rim inside 

the drip bowl. If your drip bowl is equipped with a 

hold down clip, align the element support opposite 

the terminal end with the slot in the hold down clip, 

and snap into place.

3.  After the element is positioned in the drip bowl, line 

up the terminal end with the terminal plug as shown.

4.  Hold the surface element and drip bowl together as 

level as possible and fi rmly push the terminal end 

into the terminal plug. Make sure element terminal 

is seated properly into terminal plug. Make sure the 

surface element is level to reduce the hazard of pans 

sliding off the element.

1.  Grasp the sides and lift from the front. Lift-up rod will 

support the top in its raised position. Only lift the top 

high enough to allow the support rod to rest in place 

under the front of the cooktop.

2.  Clean underneath using a clean cloth and hot, soapy 

water. 

3.  To lower the top, lift the top slightly and lower the 

rod. Lower the range top into the range frame.