Frigidaire 318201725 Manual Do Utilizador

Página de 4
1
30" Electric Range Installation Instructions
76,2 cm
(30”)
75,9 cm
(29-7/8”)
65,4 cm
(25-3/4”)
124,5 cm
(49”)
Maximum
116,8 cm (46”)
Door open
91,4 ± 0,3 cm
(36 ± 1/8”)
1.  Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b.  Location—Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must 
be solid and level.
*  76,2 cm (30") minimum clearance between the top of the cooking 
surface and the bottom of an unprotected wood or metal cabinet; 
or 61 cm (24") minimum when bottom of wood or metal cabinet is 
protected by not less than 0,64 cm (¼") flame retardant millboard 
covered with not less than no. 28 MSG sheet steel, 0,038 cm 
(0,015") stainless steel, 0,061 cm (0,024") aluminum or 0,051 cm 
(0,020") copper. The minimum clearance is 0 cm (0") for the rear 
of the range. Follow all dimension requirements provided above 
to prevent property damage, potential fire hazard, and incorrect 
countertop and cabinet cuts.
Avoid locating cabinet storage space above the surface units 
to eliminate the possibility of cabinets catching on fire, or 
personal burns from reaching for the cabinets over the heated 
units. If cabinet storage is to be provided, risk can be reduced by 
installing a range hood that projects horizontally a minimum of 
5" beyond the bottom of the cabinets.
Printed in United States 
FRONT
VIEW
BACK
VIEW
FRONT
VIEW
TYPICAL CABINET INSTALLATION
SIDE
VIEW
2,5 cm (1”)
Minimum to wall on
either side of range
above 91,4 cm (36”) height.
76,2 cm (30”)
Minimum*
76,2 cm
(30”)
45,7 cm (18”)
Minimum to cabinets
on either side of range
33 cm
(13”)
Maximum depth
for cabinets
above range top
0 cm (0”)
clearance below cooking top and rear of range.
76,5 cm
(30 1/8”)
91,4 cm
(36”)
Important Notes to the Installer
1.  Read all instructions contained in these installation instructions 
before installing the appliance.
2.  Remove all packing material before connecting the electrical 
supply to the appliance.
3.  Observe all governing codes and ordinances.
4.  Be sure to leave these instructions with the consumer.
Important Note to the Consumer
Keep these instructions with your Use and 
Care Guide for future reference.
318201725 (0904) Rev. A
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. 
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
 FOR YOUR SAFETY: Do not store or use gasoline or other 
flammable vapors and liquids in the vicinity of this or any other appliance.
Canada
United States