Elmira Stove Works 1954 Manual Do Utilizador

A. PLASTIC COVER
B. GAS PRESSURE REGULATOR CAP WITH SOLID END 

FACING OUT

C. GAS PRESSURE REGULATOR CAP WITH HOLLOW 

END FACING OUT

D. WASHER
E. GAS PRESSURE REGULATOR CAP

• Remove storage drawer. See page 17.

• Locate the regulator at the rear of storage drawer

compartment.

• Remove the plastic cover from the regulator cap.

• With your fingers, turn the nut counter clockwise.

• Do not remove the spring beneath the cap.

• Turn the cap over so LP faces up and reinstall into

regulator.

• Replace plastic cover over regulator cap.

1. Remove oven racks.

2. use a 1/2" combination wrench to loosing the orifice

hood away from the pin (about 2 to 2-1/2 turns). The
oven bake burner flame cannot be properly adjusted if
this conversion is not made. See “Adjust Oven Bake
Burner Flame” section.

A. ORIFICE HOOD
B. PIN
C. NATURAL GAS: INCREASE GAS – INCREASE FLAME SIZE (PRESET

AT FACTORY FOR NATURAL GAS)

D. LP GAS: DECREASE GAS, DEGREASE FLAME SIZE.

1. Use a 1/2" combination wrench to loosen the orifice

hood away from the pin (about 2 to 2-1/2 turns. The
oven broil burner flame cannot be properly adjusted if
this conversion is not made. See “Adjust Oven Broil
Burner Flame” section.

2. Reinstall the storage or warming drawer.

3. Complete installation. See “Make Gas Connection”

and “Electronic Ignition System” sections.

Checking for proper cooktop burner and oven bake
burner flame is very important. Natural gas flames do
not have yellow tips.

13