Thermador PRG486GD Manual Do Utilizador
PRG Professional Ranges Care and Use
Page 19
Section Four: Using the Cooktop
USING THE GRILL
Exploded Views and Side View of Grill
Burner Placement on Supports
Heat
Deflector
Deflector
Drip Pan
Grill
Box
Box
Double
U-shaped
burner
U-shaped
burner
Grill
Grate
Grate
Stainless
Steel Radiant
Steel Radiant
Venturi
Spark igniter
After removing all packaging materials, check to be
certain that the grill components are correctly as-
sembled in the grill box. The grill grates, stainless steel
radiant and the burner are assembled in the grill box
from the factory. Follow the steps below to assemble
the components in the grill box.
sembled in the grill box. The grill grates, stainless steel
radiant and the burner are assembled in the grill box
from the factory. Follow the steps below to assemble
the components in the grill box.
A. Disassemble and/or remove the grill grate, stain-
less steel Radiant and burner from the grill box.
B.
Install the aluminum rectangular drip pan inside
the grill box as shown below.
the grill box as shown below.
C. Install the heat deflector in the U Section of the
burner. Make sure that the heat deflector is slop-
ing toward the rear of the grill box.
ing toward the rear of the grill box.
D. Insert the burner venturi to the orifice located at
the front center of the grill box. The holes at the
opposite burner ends must be seated on the studs
at the rear of the grill box. Then locate the heat
deflector between the studs on sides of the the
grill can.
opposite burner ends must be seated on the studs
at the rear of the grill box. Then locate the heat
deflector between the studs on sides of the the
grill can.
E.
The stainless steel radiant lies on two (2) studs on
each end of the grill can.
each end of the grill can.
F.
Place the grill grate, with raised food containment
rail oriented towards the grill box rear.
rail oriented towards the grill box rear.
CAUTION:
•
Use extreme care when placing the
grill components into the grill
compartment. Avoid contacting the
ceramic igniter which could break
preventing operation of the grill.
grill components into the grill
compartment. Avoid contacting the
ceramic igniter which could break
preventing operation of the grill.
•
The grill must be assembled as shown.
The drip tray heat shields must be in
place, and the burner must be properly
positioned relative to the gas supply.
Incorrect assembly of the grill may
result in unsafe or hazardous
conditions during operation.
The drip tray heat shields must be in
place, and the burner must be properly
positioned relative to the gas supply.
Incorrect assembly of the grill may
result in unsafe or hazardous
conditions during operation.
•
Do not leave the grill unattended while
in use.
in use.
•
Do not use charcoal briquettes or coals
of any kind.
of any kind.