Southbend X560AA Manual Do Utilizador
500
S
ERIES
R
ESTAURANT
R
ANGES
S
ERVICE
O
WNER
’
S
M
ANUAL
1188716
(02/07) P
AGE
21
OF
44
T
ROUBLESHOOTING
B
ASE
O
VEN
CAUTION
Proper and efficient operation of oven is dependent on correct installation and function of components. Always
verify that components are in place and functioning as intended.
verify that components are in place and functioning as intended.
Consult the following table and the flowchart that begins on the following page.
Problem
Look for -
Oven will not come on.
– Oven pilot is out.
Oven pilot will not stay ignited
– Pilot gas not adjusted properly.
– Bad thermocouple.
– Bad thermocouple.
– Bad thermocouple connections at safety valve.
– Bad safety.
– Clogged orifice.
– Clogged orifice.
– Draft condition.
– Improper ventilation system.
– Air in gas line.
Figure 9
Troubleshooting Oven Pilot
Oven pilot does not work.
Does the pilot light?
No
Yes
Check that the oven pilot adjustment on the manifold is open.
Continue to hold the red button for 30 seconds. The pilot should
remain lit after the button is released. If it does not, wait five
minutes and try again.
If the pilot will not remain lit, do the following: Remove the
thermocouple from the safety valve. Install a thermocouple adapter
between the safety valve and the thermocouple to measure the
direct-current millivoltage produced by the thermocouple. While
direct-current millivoltage produced by the thermocouple. While
holding the red button, light the pilot and measure the voltage
produced by the thermocouple. If the voltage does not rise above
10 millivolts, adjust the pilot valve and retest. If the voltage still does
not quickly rise above 10 millivolts, replace the thermocouple.
If instead the thermocouple is working properly, replace the safety
valve.
If the pilot is not lit, attempt to light the pilot by raising the kick panel
slightly and rotating its top edge outward. Press and hold the red
button on the oven safety valve and put a flame to the pilot.
If the pilot still will not light, do the following: Remove the oven
bottom. Loosen the pilot nut on the burner bracket. Remove the
pilot tube from the safety valve. Remove the pilot orifice from the
pilot or end of the tube and check for debris.
Re-install the pilot orifice and tubing.
Check whether the pilot flame is lit by looking through the hole in
the bottom of the oven. Leave the oven door open for five minutes
to allow gas fumes to clear.