Dacor 106554 Manual Do Utilizador

Attach the self-rimming side panels included with the

11)

unit by snapping the ball studs on the front into the

back of the control panel and kick panel. The finished

side of each side panel faces out.
Fasten the top of each side panel to the control panel

12)

with two of the included #8 x 1/4” Torx screws (A).

Insert them through the holes created when the end

caps were removed in step 10 and tighten into place.
Finish fastening the side panels to the range using the

13)

existing screws (B) removed in step 9. Two screws will

be left over and may be discarded.

Replace the control panel end caps.

14)

Adjust the Range Height

For stand alone configurations, raise the range until

the top of the trim around the cooktop is at least

the same height as the countertop. For self-rimming

configurations, raise the

range until the bottom of

the trim surrounding the

cooktop is even with the

countertop. To adjust the

height, turn the foot on

the bottom of each leg as

shown below.
Use a level to make sure

that the range does not

tilt front to back or side to

side. Readjust the legs as

necessary.

Self-Rimming Trim Installation (cont.)

Re-attach the backguard using the supplied #8 x 1/4”

Torx screws. If there is a countertop overhang to the

rear of the range of 3/4” or greater, attach the rear

trim piece to the backguard as shown below during

re-installation.

IMPORTANT: To ensure proper fit, do

not use the screws removed from the range in previous

steps. Use only the provided #8 x 1/4” Torx screws.

Remove and retain the screws (4 each side) from the

factory installed side panels on the unit. Remove the

side panels.
Remove both control panel end cap screws and

10)

remove both end caps. The end cap screws are

accessed through holes on the under side of the trim

protruding from the front of the control panel.

Installation Instructions

down

Kick panel

A) #8 x 1/4” Torx screw included with range (2 places)

B) Existing screw removed in step 9 (6 places)

Control

panel

Ball

studs

Remove end cap,

both sides

Remove both

side panels

Rear trim

piece (optional)