Lowrance electronic LMF-200 Manual Do Utilizador

3 

When installed, the gauge will cover an area on the dash 2-3/8" (60.3 

mm) in diameter. To mount the unit, first make sure there is at least 2-

3/4" (70 mm) from the front of the dash to any obstruction behind the 

dash. The maximum usable dash thickness is 1-1/8" (28.5 mm). Also, be 

sure there is room to route the network and buzzer cables. The 

following figure shows gauge dimensions. 

 

Recommended Tools and Supplies 
Recommended tools for this job include: hole saw, 2 1/8" (54 mm) hole 

saw bit, drill, 1/8" (3 mm) drill bit (for starter hole).  
Other supplies are not included, unless otherwise indicated. If you need 

to route the gauge's network cable connector through a bulkhead, you 

will need a drill and a 3/4" drill bit. 
If the dash does not have a standard 2-1/8" (54 mm) hole, you will need 

a drill or saw to make the hole. Carefully measure the dash thickness 

and the hole area before cutting or drilling.