Kenwood TS-480SAT Manual Do Utilizador

13

q METER
While receiving, serves as an S-meter to measure
and display the received signal strength.  While
transmitting, serves as a power meter plus an ALC
meter, an SWR meter, or a Speech Processor
compression meter.  The Peak Hold function holds
each reading for approximately half a second.

w R

t

s

Appears while the internal antenna tuner {page 60} or
an external antenna tuner is in-line for the operation.

e 1

t

s

Either “1tANT” or “ANTs2” appears, depending on
which antenna connector is selected for the operation
{page 60}.

r ATT
Appears when the receiver’s attenuator (approx.
12 dB) is ON {pages 49, 61}.

t PRE
Appears when the receiver pre-amplifier (approx.
6 dB) is ON {page 49}.

y VOX
Appears when the VOX (Voice Operated
Transmission) function is ON or the Break-in function
is ON for the CW mode {pages 36, 39}.

u PROC
Appears when the Speech Processor function is ON
{page 37}.

i MENU
Appears when configuring the parameters in the
Menu mode {page 22}.

o 
Reserved for future updates.

q w

e

r t y u

o!0 !1

!4 !5 !6 !7 !8!9

i

!2

!3

!0 
Appears while the Constant Recording function is
working {page 69}.

!1 NB
Appears when the Noise Blanker is ON {page 47}.

!2 AGC OFF
“AGC  - F” (fast) or “AGC” (slow) appears when the
AGC (Automatic Gain Control) function is ON.  “AGC
OFF” appears when the AGC is OFF {page 35}.

!3 NAR 2
“NAR” appears when the narrow IF filter is selected
for the operating mode.  If 2 optional IF filters are
installed and the transceiver selects the secondary IF
filter, “NAR 2” appears {page 45}.

!4 MHz
Appears when the MHz Up/ Down mode using the
MULTI control is ON {page 34}.  It also appears when
the Quick Menu function is ON {page 22}.

!5 FINE
Appears when the Fine function is ON {page 35}.

!6 
Appears when the selected Menu No. is in the Quick
Menu list.  It also appears when the transceiver is
scanning the frequencies between the slow down
frequency points {page 57}.

!7 
Appears when the split-frequency operation is ON
{page 30}.

!8 
Appears when the Tuning control Lock function is ON
{page 63}.

!9 
Appears when the Frequency Lock function is ON
{page 63}.