Kenwood TK-3131 Manual Do Utilizador
14
5
Press the PTT, MON, or CAL key to exit
Setting Mode.
Setting Mode.
To begin scanning:
1
Press and hold the
▲ key for 1 second.
•
“
” appears on the display.
2
When a signal is detected and the QT/ DQT
matches, the channel number appears on the
display and blinks.
matches, the channel number appears on the
display and blinks.
3
When the signal is no longer present, the
transceiver waits for 5 seconds before
scanning continues.
transceiver waits for 5 seconds before
scanning continues.
•
If a new signal appears before the 5 seconds
elapse, the transceiver will remain on the
channel until the new signal is no longer
present, at which time it will again wait for
5 seconds before continuing.
elapse, the transceiver will remain on the
channel until the new signal is no longer
present, at which time it will again wait for
5 seconds before continuing.
4
To end the scan at any time, press and hold
the
the
▲ key for 1 second.
•
The transceiver returns to the channel you
were using before you started scanning.
were using before you started scanning.