Kenwood TK-7150 Manual Do Utilizador

TK-7150

Setting method refer to “ADJUSTMENT”.

Setting method refer to “ADJUSTMENT”.

The transceiver is programmed by using a personal com-

puter, programming interface (KPG-46) and programming
software (KPG-79D).

The programming software can be used with an IBM PC

or compatible.  Figure 1 shows the setup of an IBM PC for
programming.

1. Connect the transceiver to the personal computer with

the interface cable.

2. When the Power switch on, user mode can be entered

immediately.  When PC sends command the radio enter
PC mode, and “PROGRAM” is displayed on the LCD.
When data transmitting from transceiver, the red LED is
blinking.
When data receiving to transceiver, the green LED is blink-
ing.

The KPG-46 is required to interface the transceiver to the

computer.  It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.

The KPG-46 connects the modular microphone jack of the

transceiver to the computers RS-232C serial port.

The KPG-79D programming disk is supplied in 3-1/2” disk

format.  The software on this disk allows a user to program
the transceiver radio via programming interface cable (KPG-
46).

User mode

For normal use.

Panel test mode

Used by the dealer to check the funda-

ment characteristics.

Panel tuning mode

Used by the dealer to tune the radio.

PC mode

Used for communication between the

radio and PC (IBM compatible).

FPU data program-

Used to read and write frequency data and

ming mode

other features to and from the radio.

PC test mode

Used to check the radio using the PC.

This feature is included in the FPU.

See panel tuning.

Firmware program-

Used when changing the main program of

ming mode

the flash memory.

Clone mode

Used to transfer programming data from

one radio to another.

Firmware version

Used to confirm the internal firmware

information

version.

User mode

Power ON

Panel test mode

[PF1]+Power ON

Panel tuning mode

[Panel test mode]+[PF3]

PC mode

Received commands from PC

Firmware programming mode

[PF2]+Power ON

Checksum display mode

[Firmware programming mode]+[PF5]

Clone mode

[PF6]+Power ON

Firmware version information

[PF3]+Power ON (one second)

User mode

Panel test mode

Panel tuning mode

PC mode

FPU data programming mode

Firmware program-
ming mode

PC test mode

PC tuning mode

Checksum
display mode

Clone mode

Firmware version
information

[PF1]+Power on

[PF6]+Power on

[PF3]+Power on

[PF3]

[PF5]

[PF4]

KPG-46 or
KPG-46 +
Tuning cable
(E30-3383-05)

TK-7150

IBM PC

KPG-79D