Kenwood TK-7150 Manual Do Utilizador

TK-7150

1. Remove the short plug from the 6-pin accessory connec-

tor on the rear of the radio. (Remove the jumpers as de-
scribed in Section 3-1.)

2. Cut off the end of the protective cover, insert the speaker

cable into the protective cover, and insert it into pins 2 and
3.

3. Install the plug and protective cover on the accessory con-

nector on the rear of the transceiver, then clamp the bot-
tom of the protective cover with the supplied tie wrap.

4. If you remove jumper shorting pins 5 and 6, the 20W PA

(public address) voice signal is output from pins 2 and 3.
(Only when the PA or SP switch is on.)

5. If you use the radio with pins 5 and 6 shorted, the internal

speaker is available.

• Relation ship between accessory connector (6-pins) con-

nection and speaker output.

• When pins 5 and 6 are shorted; The internal speaker is

used.

• When pins 5 and 6 are open and output is from pins 2 and

3; The 20W external speaker is used.

Cut

Tie wrap

Black lead

Black/White lead

Protective cover

2

3

Short plug

Speaker cable

1. Lift the tab on the bottom of the transceiver, then pull the

panel away from the transceiver.

2. Remove the connector that binds the display unit to the

TX-RX unit.

3. As shown in Figure 5-1, make sure that the rubber seal is

placed above the cable, then plug the 11-pin connector
into the front panel PCB assembly.

4. Also, affix the ground wire to the front panel chassis, as

shown in Figure 5-1, with the supplied screw.

5. Choose the remote wire position (right side or left side),

then place the seal within the guide rail.  Attach and se-
cure the cover using the 2 binding screws.

6. Plug the 12-pin connector (from the rear panel) to the

CN902 socket on the display PCB, as shown in Figure 5-2.

7. Push and secure the panel into the chassis so that the 6

tabs on the top and bottom are securely fixed.

8. Plug the connector from the main panel into the CN703

socket (Figure 5-3).

9. Push and secure the main panel so that the 6 tabs on the

top and bottom of the panel are securely fixed.

Rubber seal

KCT-22

Ground wire

Display unit

CN902

Rear panel

Main panel

CN703