Kenwood TK-5710 Manual Do Utilizador

11

Press the   switch to switch the transceiver ON.

• A beep sounds and the display momentarily lights up.
• If the Transceiver Password function is programmed, “PASSWORD” appears on the

display.  You must enter the password to unlock the transceiver.  Refer to “Transceiver
Password”, below.

Press and hold the   switch for approximately 1 second to switch the transceiver
OFF.

■

To enter the password:

1 Rotate the CH control to select a digit.

2 Press the GRP 

 key to accept the entered digit and move to the next

digit.

3 Repeat steps 1 and 2 to enter the entire password.

• The password can contain a maximum of 6 digits.
• Press the PF 3 key (the third key from the left, after the CH control) to delete an

incorrectly entered character.  Press and hold the PF 3 key to delete all
characters.

4 Press the PF 2 key (the second key from the left, after the CH control) to

confirm the password.

• If you enter an incorrect password, an error tone sounds and the transceiver

remains locked.

To enter the password using a DTMF keypad:

1 Press the DTMF keys corresponding to the password digits.

• The password can contain a maximum of 6 digits.
• Press the PF 3 (the third key from the left, after the CH control) or DTMF # key

to delete an incorrectly entered character.  Press and hold the PF 3 or DTMF #
key to delete all characters.

2 Press the PF 2 or DTMF

key to confirm the password.

• If you enter an incorrect password, an error tone sounds and the transceiver

remains locked.

Rotate the VOL control clockwise to increase the volume and counterclockwise
to decrease the volume.