Kenwood TK-5910 Manual Do Utilizador

3

For passenger safety, install the transceiver securely using an optional mounting bracket and screw 

set so the transceiver will not break loose in the event of a collision.

1  Mark the position of the holes in the dash by using the mounting bracket as a 

template.  Drill the holes, then attach the mounting bracket using self-tapping 

screws.

•  Be sure to mount the transceiver in a location where the controls are within easy 

reach of the user and where there is sufficient space at the rear of the transceiver for 

cable connections.

2  Connect the antenna and power cable to the transceiver.
3  Slide the transceiver into the mounting bracket and secure it using  

hex-headed screws.

4  Mount a microphone hanger in a location where it will be within easy reach of 

the user yet not interfere with the safe operation of the vehicle.

When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same value.  

Never replace a fuse with a fuse that has a higher value.

Hex-headed

screws

DC power 

cable

Mounting 

bracket

Antenna 

connector

Power input 

connector

Fuse holder

Black (–) cable

Red (+) cable

 V vehicle 

battery

Microphone

Microphone 

hanger

Short plug

Fuse

Hex-headed

screw

Ground lead

(commercially available)

*  The TK-570/ TK-580 is shown in the above diagram.

Note:  The items above shown in gray are optional accessories.