IBM 1000-90 Manual Do Utilizador
COMM.EXE
7
Sending Files to the Computer
LAI-2000Plant Canopy Analyzer
The LAI-2000 is configured as a DCE device. Connect the LAI-
2000 to your computer using the printer cable provided with the
instrument. To send files from the LAI-2000 to a computer, use the
following functions, found in the COMM execute list:
2000 to your computer using the printer cable provided with the
instrument. To send files from the LAI-2000 to a computer, use the
following functions, found in the COMM execute list:
FCT 31 - Configure the I/O port for 4800 baud, 8 data bits, no
parity, and xon/xoff = NO.
parity, and xon/xoff = NO.
FCT 33 - Set the desired output format (Normal, with or without
observations, or Spreadsheet format).
observations, or Spreadsheet format).
FCT 32 - Print the desired range of files.
LI-1000 DataLogger
The LI-1000 is configured as a DTE device. Most computers can be
connected to the LI-1000 using the 1000-03 printer cable and a
female-to-female gender changer. To send files from the LI-1000 to
a computer, follow these steps:
connected to the LI-1000 using the 1000-03 printer cable and a
female-to-female gender changer. To send files from the LI-1000 to
a computer, follow these steps:
1.
Press
OUT
on the LI-1000.
2.
Select the proper baud rate (toggle with any key except
ENTER
).
"Baud = 3" is 300 baud, and "baud = 48" is 4800 baud. Press
ENTER
.
3.
Select either "
V
" for vertical format or "
H
" for horizontal format.
Vertical format gives one number per line, and horizontal format
gives as many numbers per line as will fit in the line length
specified. Press
gives as many numbers per line as will fit in the line length
specified. Press
ENTER
.
4.
If "H" was chosen in step 3, the next display will be "len=".
Enter the maximum number of characters in a line for your
computer or printer. Press
Enter the maximum number of characters in a line for your
computer or printer. Press
ENTER
. The following display is
"dump all=yes" (no) (LI-1000 software version 2.xx only).
Toggle yes or no, and press
Toggle yes or no, and press
ENTER
. The LI-1000 display will
show "dumping".