Vertex Standard FT-857 Manual Do Utilizador
91
FT-857 Operating Manual
Beacon Transmission (On the Air)
1. Press and hold in the [FUNC] key for one second to enter the Menu mode.
2. Rotate the SELECT knob to select Menu Mode No-012 [BEACON TIME].
3. Rotate the DIAL to select the interval time (between repeats of the message) (1 ~ 255
2. Rotate the SELECT knob to select Menu Mode No-012 [BEACON TIME].
3. Rotate the DIAL to select the interval time (between repeats of the message) (1 ~ 255
seconds).
4. Press and hold in the [FUNC] key for one second to exit to normal operation.
5. Press the [FUNC] key momentarily, then rotate the SELECT knob, as needed, until
5. Press the [FUNC] key momentarily, then rotate the SELECT knob, as needed, until
Multi Function Row “o” [PLY1, PLY2, PLY3] appears on the display.
6. Press the [A](PLY1) key to activate the Beacon Feature.
1) When using the “beacon” feature, please disable the “VOX” feature.
2) If you press [B](PLY2) or [C](PLY1), the message will be transmitted, after
2) If you press [B](PLY2) or [C](PLY1), the message will be transmitted, after
which the transmission will halt. Operationally, these two keys function the same as a
traditional CW message keyer, while the [A](PLY1) key is used as the repetitive “bea-
con” text.
traditional CW message keyer, while the [A](PLY1) key is used as the repetitive “bea-
con” text.
7. To stop a repeating beacon message, just press the [A](PLY1) key momentarily.
8. To disable transmission from the Beacon, just repeat the above procedure, rotating the
8. To disable transmission from the Beacon, just repeat the above procedure, rotating the
DIAL to select “OFF” in step 3 above.
You may adjust the CW speed using Menu Mode No-030 [CW SPEED].
You may also send the Beacon Text manually. If this is done, all three “Beacon” messages
may be used as a traditional CW message keyer. To do this:
may be used as a traditional CW message keyer. To do this:
1. Press and hold in the [FUNC] key for one second to enter the Menu mode.
2. Rotate the SELECT knob to select Menu Mode No-012 [BEACON TIME].
3. Rotate the DIAL to select “OFF.”
4. Press and hold in the [FUNC] key for one second to exit to normal operation.
5. Press the [FUNC] key momentarily, then rotate the SELECT knob, as needed, until
2. Rotate the SELECT knob to select Menu Mode No-012 [BEACON TIME].
3. Rotate the DIAL to select “OFF.”
4. Press and hold in the [FUNC] key for one second to exit to normal operation.
5. Press the [FUNC] key momentarily, then rotate the SELECT knob, as needed, until
Multi Function Row “o” [PLY1, PLY2, PLY3] appears on the display.
6. Press the [A](PLY1) key momentarily to send the “BEACON TEXT 1” message. Alterna-
tively, pressing the [B](PLY2) or [C](PLY3) key will initiate the message at those re-
spective break points.
spective break points.
M
ISCELLANEOUS
S
ETTINGS
B
EACON
F
EATURE