Vertex Standard VX-8R Manual Do Utilizador
VX-8R O
PERATING
M
ANUAL
9
I
NSTALLATION
OF
FNB-101LI B
ATTERY
P
ACK
The FNB-101LI is a high-performance Lithium-Ion battery providing high capacity in a
very compact package. Under normal use, the FNB-101LI may be used for approxi-
mately 300 charge cycles, after which operating time may be expected to decrease. An old
battery pack, which is displaying diminished capacity should be replaced with a new one.
very compact package. Under normal use, the FNB-101LI may be used for approxi-
mately 300 charge cycles, after which operating time may be expected to decrease. An old
battery pack, which is displaying diminished capacity should be replaced with a new one.
To install the FNB-101LI Battery Pack, carefully mate the
battery’s three alignment tabs with their corresponding align-
ment slots on the transceiver bottom case, then gently press
the top side of the Battery Pack until it locks in place with a
“click”.
ment slots on the transceiver bottom case, then gently press
the top side of the Battery Pack until it locks in place with a
“click”.
To remove the Battery Pack, turn the transceiver off and
remove any protective cases. Press the Battery Pack Release
Knobs downward to unlock the latch, then remove the Bat-
tery Pack from the transceiver.
Knobs downward to unlock the latch, then remove the Bat-
tery Pack from the transceiver.
The VX-8R battery must be correctly installed, to
maintain the waterproof integrity.
maintain the waterproof integrity.
I
NSTALLATION
OF
A
CCESSORIES
R
EMOVE
B
ATTERY
P
ACK
R
ELEASE
K
NOB
I
NSTALL
If the battery has never been used, or its charge is depleted, it may be charged by connect-
ing the NC-86B/C Battery Charger, as shown in the illustration, to the EXT DC jack. If
only 12 ~ 16 Volt DC power is available, the optional E-DC-5B DC Adapter (with its
cigarette lighter plug) or E-DC-6 DC Cable may also be used for charging the battery, as
shown in the illustration.
ing the NC-86B/C Battery Charger, as shown in the illustration, to the EXT DC jack. If
only 12 ~ 16 Volt DC power is available, the optional E-DC-5B DC Adapter (with its
cigarette lighter plug) or E-DC-6 DC Cable may also be used for charging the battery, as
shown in the illustration.
While the battery is being charged, the display will indicate “CHARGING
CHARGING
CHARGING
CHARGING
CHARGING
” and the
key
will glow red. The S-meter will deflect according to the charging status. When charging is
finished, the display will change to indicate “COMPLETE
finished, the display will change to indicate “COMPLETE
COMPLETE
COMPLETE
COMPLETE
COMPLETE
” and the
key will glow green.
E-DC-6
E-DC-5B
NC-86