Yamaha T8D Manual Do Utilizador
Operation
36
2.
After stopping the engine, disconnect the
fuel line or close the fuel cock if there is a
fuel joint or a fuel cock on the boat.
fuel line or close the fuel cock if there is a
fuel joint or a fuel cock on the boat.
3.
Tighten the air vent screw on the fuel tank
cap (if equipped).
cap (if equipped).
4.
Remove the key if the boat will be left un-
attended.
attended.
NOTE:
The engine can also be stopped by pulling the
lanyard and removing the clip from the engine
stop switch, then turning the main switch to
“
lanyard and removing the clip from the engine
stop switch, then turning the main switch to
“
” (off).
EMU27861
Trimming outboard motor
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim an-
gle depends upon the combination of boat,
engine, and propeller. Correct trim is also af-
fected by variables such as the load in the
boat, sea conditions, and running speed.
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim an-
gle depends upon the combination of boat,
engine, and propeller. Correct trim is also af-
fected by variables such as the load in the
boat, sea conditions, and running speed.
WARNING
EWM00740
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
EMU27871
Adjusting trim angle for manual tilt
models
models
There are 4 or 5 holes provided in the clamp
bracket to adjust the outboard motor trim an-
gle.
1.
bracket to adjust the outboard motor trim an-
gle.
1.
Stop the engine.
2.
Remove the trim rod from the clamp
bracket while slightly tilting the outboard
motor up.
bracket while slightly tilting the outboard
motor up.
1. Trim operating angle
1. Trim rod
ZMU02043
1
U60R10E0.book Page 36 Monday, June 21, 2004 9:34 AM