Lowrance electronic HDS 8 Manual Do Utilizador

  Slip the clamp around the trolling motor, as shown   

 

below. Tighten the hose clamp securely to  

 

 

the trolling motor.

   Slide the hose    

 

clamp  through the Pod  

 

transducer brackets, as  

 

shown below.

Hose  

clamp

Hose  

clamp

Cable ties

Cable ties

Transducer

The top of the transducer is curved to fit the contour of the trolling 

motor. 

You will need a hose clamp large enough to fit over the 

trolling motor. The hose clamp is NOT included with the Pod 

transducer. 

Before you attach the transducer to the trolling motor, make sure there is enough 

slack in the transducer cable for the trolling motor to turn freely.

 The transducer should be mounted ahead of the trolling motor fin. Position the 

transducer to so its face is pointing straight down when the trolling motor is in the water.

Route the transducer cable along the trolling motor shaft. Use plastic ties (not included) to 

secure the cable to the shaft.