Panasonic UB-8325 Manual Do Utilizador

The unit is capable of producing about 15 more copies 
when the Contrast/Remaining Film Indicator begins to 
flash. The unit has run out of thermal transfer film and 
can no longer make copies when the Multi-Copy/Error 
Indicator flashes “

”. Separately available 

replacement film (UG-6001) may be purchased from 
the dealer where you purchased the unit. Thermal 
transfer film is replaced as follows.

• Only use the designated product (UG-6001) from 

Panasonic as the replacement film. (Note that using 
another type of replacement film may result in 
degraded printing quality or damage to the unit.)

• Thermal transfer film is disposable. Dispose of used 

thermal transfer film as “burnable” or “non-
recyclable” rubbish.

• A negative of the copied image will remain on the 

thermal transfer film. To protect the security of your 
information, we recommend cutting up the used 
thermal transfer film with scissors or shredder before 
disposing of it.

Push down the printer open lever to open the 
printer door, and remove the used film.

Refer to steps 3 and 4 in the section of 
“Installing the Thermal Transfer Film” on page 
18.

•If “ ” is still flashing after closing the printer 

door, make sure that the thermal transfer film 
has been installed properly and tightened.

•The printer door should be closed to make 

copies properly. Confirm both latches are 
locked.