Panasonic UB-8325 Manual Do Utilizador

Turn on the Interactive Panaboard.

Turn on your computer and start up Windows.

For Windows 2000 / Windows XP
Connect the USB cable provided from the 
electronic board to the computer.
•The Interactive Panaboard Software is 

automatically started.

For WIndows 98 / Windows Me
Click [Start] and select Programs - 
Panasonic - Interactive Panaboard - 
Interactive Panaboard.
•The window appears to show the Interactive 

Panaboard is detected.

•If the Panaboard Operation Panel is 

displayed using the Panasonic-DMS, the 
Panasonic Interactive Software cannot be 
started. Close the Panaboard Operation 
Panel and start it. Refer to page 72.

•To change the setting so the Interactive 

Panaboard Software is not started 
automatically when connecting the USB 
cable, perfrom the following.

(1) Connect the USB cable provided from the 

electronic board to the computer.

(2) Click [Start] and select Settings - 

Control Panel, then double-click 
Scanners and Cameras icon. 
(For Windows XP, click [start] and select 
Control Panel)

(3) Double-click Panaboard-UB8 USB 

Device Driver icon and click the Disable 
device events check box in the Events 
tab. Click [OK].

To start the Interactive Panaboard Software, 
click [Start] and select Programs - 
Panasonic - Interactive Panaboard - 
Interactive Panaboard.
(For Windows® XP, All Programs instead of 
Programs)

Click [OK].

•The Select Mode window appears.

Click Projector icon and click [OK].

•The calibration start screen is displayed.

•If the Interactive Panaboard and projector 

are fixed not to move, then the calibration 
has been performed, it enables to skip the 
following calibration step by checking the 
Use the last Calibration setting check box. 

If the Desktop resolution is different from the 
setting when the calibration was executed 
before, Interactive Panaboard Software will 
not function properly. In that case, calibrate 
from the pop-up menu of the Taskbar. (See 
page 34.)

 

To calibrate the position of the computer 
screen, press the center of each corner for 
about two seconds in the following order with 
the Electronic Pen.

•When a position ended correctly, then the 

next position starts automatically.

•When the calibration ended correctly, the 

message is displayed to notify it.