Panasonic UB-8325 Manual Do Utilizador

It is possible to perform the same operations as with the electronic board control panel (page 16) from the following 
Panaboard Operation buttons.

•While the Panaboard Operation Panel is displayed, the 

 (Copy Key) and 

 (2-Screen Copy Key) on 

the electronic board control panel are used for scanning images into the computer.

This lamp indicator notifies the user when the time to replace the 
thermal transfer film is approaching (estimated) and of the contrast used 
during scanning or copying.
Indicator off: 

Normal scanning or copying contrast

Indicator on: 

Darker than normal scanning or copying contrast

Indicator flashing*:

Almost time to replace the thermal transfer film
(Note that only about 15 more sheets may be 
copied when this indicator starts flashing.)
Replacement film (UG-6001) is separately 
available from the dealer where you purchased 
your unit.

Each time this button is pressed, the unit will alternate between normal 
and dark contrast modes (Normal/Dark).

This button scans the front and back of the screen on a single page.

This indicator displays the number of copies to be made. The display 
changes each time the Multi-Copy/Stop Button is pressed.

Example: 1 

→  2 →  ··· →  9 →  1 →  ···

When an error occurs, a flashing symbol will appear in this display to 
indicate the error status. (See page 80.)

When making multiple copies, press this button until the desired number 
of copies is displayed on the Multi-Copy/Error Indicator. This button can 
also be pressed to stop copying while executing multiple copies.
• The display changes as shown below each time the screen is copied. 

After reaching 0, the display will reset to 1.

Example: 5 

→  4 →  3 →  2 →  1 →  0 →  1 

(Number is counted down.)

This button scans the screen.

Clicking this button advances the screen from right to left.

This button causes the front and back of the screen to be copied on a 
single sheet of paper.