Kawasaki STX-15F Manual Do Utilizador
PUMP AND IMPELLER 11-11
Pump and Impeller
•
Remove the bearing by tapping evenly around the bearing
inner race from the front end of the pump case [A].
inner race from the front end of the pump case [A].
Special Tool - Bearing Driver Set: 57001-1129 [B]
JT1500-A2
∼
;
•
Press [A] the bussing [B] and the ball bearing [C]. They
come out of the pump case.
come out of the pump case.
•
Remove the circlip.
•
Remove the grease seals.
Special Tool - Oil Seal & Bearing Remover: 57001-1058 [A]
JT1500-A1,A2
∼
;
•
Insert a metal rod [A] into the pump cap [B] from the rear
end, remove the bearing by tapping evenly around the
bearing inner race from the rear end of the pump cap.
end, remove the bearing by tapping evenly around the
bearing inner race from the rear end of the pump cap.
Pump Assembly
•
Before installing the cap bearing, blow any dirt or foreign
particles out of the pump cap [A] with compressed air.
particles out of the pump cap [A] with compressed air.
•
Install new bearing into the cap as far as it will go.
Special Tool - Bearing Driver Set: 57001-1129 [B]