Clearblue Boat Manual Do Utilizador

CLEAR BLUE HAWAII

2123 Eluwene St. Honolulu, HI 96819

TOLL FREE : 1-877-777-6708

INTERNATIONAL : 1-707-202-8346   FAX : 1-707-317-5367

www.clearbluehawaii.com

Molokai Kayak Instructions

Insert cross ribs

Install cross rib (A) first

Cross rib (A) is the largest piece and is installed at the center of the base rod.  When clipped 
together, secure the side rib to the base rod by wrapping the black rubber band around the top 
of the clip (see previous image)

1. 

Cross rib (A) and (B2) are very similar, please ensure you have the right 
part, cross rib (A) is wider when put against (B2). 

Lock the cross rib onto the side rod

The end of each cross rib has a lockable clip, when it is at 
a right angle to the side rod, it is unlocked. To lock the 
clip, push it towards the side of the kayak 

2. 

Mount cross ribs (B1) and (B2)

The rear of Molokai Kayak will be where (B1) is installed, 
this is behind cross rib (A) at the opposite side to the clear 
viewing panel.

3. 

Insert the final four cross ribs, (C) and (D)

As the remaining ribs are installed the kayak will begin to take shape and the base rod will 
become straight. The final few pieces may require more effort than the earlier cross ribs, again 
this is normal as the kayak frame is completed and gains strength.

4. 

Attach the arches

Find the two arches and attach them to the inside of the frame on either side by rolling the 
Velcro tightly.  This will create arches that will tighten the top skin once attached.

6. 

Secure top skin

Place each end of the top skin over the two ends of Molokai Kayak first and then go around the 
edges securing the Velcro.

7. 

Inflate the side air tubes one at a time until firm

5. 

*Assembly Tip