Mercury Marine 899846001 Manual Do Utilizador

REPAIRS

ONE PART GLUE (EMERGENCY REPAIRS ONLY)

Follow the directions on the cement tube.

TWO PART ADHESIVE

Mix a batch of adhesive according to the mixing directions provided

with the adhesive. Keep adhesive off skin. When the adhesive is

fully mixed, it must sit for a short time to activate the catalyst.

Failure to do so will create poor fabric adhesion.
Apply two thin layers of adhesive using a short bristle brush, in a

circular pattern on both the backside of the patch and the patch

area on the boat. Allow the first layer to dry completely

(approximately 15 minutes) before applying the second layer. The

second layer should dry until tacky, then apply the patch to the

prepared area and press down firmly. Using a smooth object (the

back of a tablespoon works well), force out any air bubbles that

may have been trapped under the patch, working from the center

of the patch to the outside.
After removing the masking tape, use solvent to clean up any

excess glue, then place a 4 ‑ 5 pound weight onto the patch and

allow 24 hours drying time before pressurizing the repaired air

chamber.

Air Chamber Repair ‑ PVC Fabric

WARNING

Avoid serious injury or death from a fire, explosion or poisoning.

The glues and solvents used for repairing inflatables are toxic

and highly flammable. As a safety precaution, always work

outdoors or in an area that is well‑ventilated, and away from any

open flames, sparks, or appliances equipped with pilot lights.

Breathing the vapors or exposure to the skin may be hazardous

to your health. Avoid breathing the vapors and contact with skin

and eyes by wearing a carbon filter respirator and protective gear

over all exposed areas of the body.