Garmin 160C Manual Do Utilizador

I

NSTALLING

 

THE

 F

ISHFINDER

 160C > 

T

RANSDUCER

 I

NSTALLATION

1.  Align the slot on the back of the unit with the long mounting 

knob and slide into place. It may be necessary to adjust the 

long knob to spread the bracket arms apart. (Turn counter-

clockwise to widen the bracket arms, clockwise to tighten.)

2.  Adjust the unit angle and tighten the long mounting knob until 

snug.

3.  Tilt the unit by loosening the long knob on the right side of the 

bracket assembly.

4.  Rotate the entire bracket by twisting it left or right. (

NOTE: 

You will hear clicks as you turn the bracket.)

5.  Tighten all knobs when the viewing angle you want is 

obtained.

Once you’ve installed the Fishfinder 160C unit, you must install the 

transducer for it to function. The included transducer can be installed 

).

1.  Insert the rubber washer and plastic spacer in the transducer 

at the same time. DO NOT lubricate the rubber washer.

2.  Route the cable toward the back and slide the transducer into 

the mounting bracket.

3.  Place a 5 mm flat washer on the 10-32 x 1.75" screw and 

insert the screw through the mounting bracket, spacer, and 

rubber washer.

4.  Place the remaining 5 mm flat washer on the exposed end, 

and install the 10-32 lock nut finger tight. The transducer is 

tightened further after installation on the boat.