Garmin 160C Manual Do Utilizador

I

NSTALLING

 

THE

 F

ISHFINDER

 160C > 

T

RANSDUCER

 I

NSTALLATION

1.  Slide the large cable tie through the slot on the transducer 

mount with the ridges of the band facing up until equal 

lengths extend on both sides of the mount. (

NOTE: For cold 

water, or heavy timber or debris areas, a metal 4-5" worm 

gear clamp is recommended.)

2.  Position the mount gasket on the curved top of the transducer 

mount.

3.  Place the transducer assembly against the motor body of the 

trolling motor, with the front of the transducer pointed away 

from the trolling motor propeller. 

4.  Wrap the two ends of the cable tie around the motor body. 

Place the pointed end of the cable tie through the fastener 

hole on the opposite end and pull it through until it is snug but 

not tight. (The cable tie clicks when you pull it.)

5.  Position the transducer so that it is parallel with the bottom 

when in use, and make sure the gasket is aligned properly. 

Pull the cable tie end until tight. Trim off the excess, if 

necessary. Tighten the 10-32 locking nut until it touches the 

mounting bracket and then tighten 1/4 turn more. (Do not 

overtighten.)

6.  Route the 30' (9 m) transducer cable using the supplied cable 

ties to secure the cable to the motor shaft. You can fill the 

forward-facing portion (except the cable tie pocket) of the 

transducer mount with sealant to avoid accumulating debris.