Weber 42390 Manual Do Utilizador
9
WARNING: Only use this grill outdoors in a
well-ventilated area. Do not use in a garage, building,
breezeway or any other enclosed area.
well-ventilated area. Do not use in a garage, building,
breezeway or any other enclosed area.
CHECK THAT ALL BURNER VALVES ARE OFF
Valves are shipped in the OFF position, but you should check to be sure
that they are turned OFF. Check by pushing down and turning clockwise.
If they do not turn, they are off. Proceed to the next step. If they do turn,
continue turning them clockwise until they stop, then they are off. Pro-
ceed to the next step.
that they are turned OFF. Check by pushing down and turning clockwise.
If they do not turn, they are off. Proceed to the next step. If they do turn,
continue turning them clockwise until they stop, then they are off. Pro-
ceed to the next step.
IMPORTANT LP CYLINDER INFORMATION
Failure to follow these DANGER statements exactly may result in a fi re
causing death or serious injury.
causing death or serious injury.
DANGER
NEVER store a spare LP cylinder under or near
this barbecue.
NEVER fi ll the tank beyond 80% full.
this barbecue.
NEVER fi ll the tank beyond 80% full.
Note: This connection tightens clockwise and will not allow gas to fl ow
unless the connection is tight. The connection requires tightening by hand
only.
unless the connection is tight. The connection requires tightening by hand
only.
WARNING: Do not use a wrench to tighten the
connection. Using a wrench could damage the
regulator coupling and could cause a leak.
regulator coupling and could cause a leak.
5)
Mix soap and water.
Some of the tanks have differing top collar assembles. (The top collar is the
metal protective ring around the valve.) One series of tanks mount with the
valve facing front. The other tanks mount with the valve facing away from
the fuel scale. These types of tanks are illustrated below.
You will need: LP cylinder, a soap and water solution and a rag or brush to
apply it.
1)
metal protective ring around the valve.) One series of tanks mount with the
valve facing front. The other tanks mount with the valve facing away from
the fuel scale. These types of tanks are illustrated below.
You will need: LP cylinder, a soap and water solution and a rag or brush to
apply it.
1)
Turn the LP cylinder so the opening of the valve is either to the front,
side or rear of the Weber
side or rear of the Weber
®
gas barbecue. Lift and hook the cylinder
onto the fuel gauge.
2)
Loosen the cylinder lock wing nut. Swing the cylinder lock down.
Tighten the wing nut.
To Connect the hose to the cylinder:
3)
Remove the plastic dust cover from the valve.
4)
Screw the regulator coupling onto the tank valve, clockwise, or to the
right. Hand-tighten only.
right. Hand-tighten only.
CONNECTING THE LIQUID PROPANE CYLINDER
WARNING: Make sure that the LP cylinder valve is
closed. Close by turning valve clockwise.
DANGER
Do not use an open fl ame to check for
gas leaks. Be sure there are no sparks or
open fl ames in the area while you check
for leaks. Sparks or fl ames will result in a
fi re or explosion which can cause serious
bodily injury or death, and damage to
property.
gas leaks. Be sure there are no sparks or
open fl ames in the area while you check
for leaks. Sparks or fl ames will result in a
fi re or explosion which can cause serious
bodily injury or death, and damage to
property.
GAS INSTRUCTIONS
ATTENTION: This product has been safety
tested and is only certifi ed for use in a specifi c
country. Refer to country designation located on
outer carton.
tested and is only certifi ed for use in a specifi c
country. Refer to country designation located on
outer carton.
These parts may be gas carrying or gas burning components.
Please contact Weber-Stephen Products Co., Customer Service
Department for genuine Weber-Stephen Products Co. replacement
part(s) information.
Please contact Weber-Stephen Products Co., Customer Service
Department for genuine Weber-Stephen Products Co. replacement
part(s) information.
WARNING: Do not attempt to make any repair
to gas carrying or gas burning components
without contacting Weber-Stephen Products Co.,
Customer Service Department. Your actions,
if you fail to follow this product Warning, may
cause a fi re or an explosion resulting in serious
personal injury or death and damage to property.
to gas carrying or gas burning components
without contacting Weber-Stephen Products Co.,
Customer Service Department. Your actions,
if you fail to follow this product Warning, may
cause a fi re or an explosion resulting in serious
personal injury or death and damage to property.