Weber Summit Gas Griill Manual Do Utilizador

CROSSOVER

IGNITION SYSTEM OPERATIONS

If the Crossover

ignition system fails to ignite the LEFT burner in a burner

set, light the LEFT burner with a match. If the LEFT burner lights with a
match, then check the Crossover

ignition system.

•

Check that both ignition wires(1,2) are attached properly.

•

Check that the Crossover

ignition button is activating.

•

You should hear the igniter sparking.

If the Crossover

ignition system still fails to light, contact the Customer

Service Representative in your area using the contact information on our
web site. Log onto www.weber.com

(1 )

(2 )

MAINTENANCE

REPLACE IGNITER BATTERIES

Parts required: 1 AA alkaline battery per igniter.

Unscrew igniter button from bottom of control panel. Remove igniter button
and contact spring. Remove old battery and replace with a new AA alkaline
battery. Positive end(1) of battery faces up as shown in illustration. Replace
spring contact(2) and screw igniter button(3) back down.

ATTENTION: This product has been safety tested and is only certifi ed for use in a specifi c country. Refer to
country designation located on outer carton.

These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for
genuine Weber-Stephen Products Co. replacement part(s) information.

WARNING: Do not attempt to make any repair to gas carrying or gas burning components without contacting
Weber-Stephen Products Co., Customer Service Department. Your actions, if you fail to follow this product
Warning, may cause a fi re or an explosion resulting in serious personal injury or death and damage to property.