Enviro 828 BV. FS. Manual Do Utilizador

13. 

Re-attach the hinged side flaps by sandwiching the 
surround panels between the mounting brackets and the 
hinged side flaps.  secure with screws. 

 
14. Re-install the stove top by inserting the locating screws, 

previously put into the surround panel top, through the 
holes in the back of the stove top. Push threaded studs 
through holes in top baffle and tighten nuts.  Re-attach the 
top grill bar. 

 
15. 

Be sure to maintain adequate clearances around air 
openings, do not block. 

 
16. 

Place the log and ember set into the fire box. See 
instructions in section 11, INSTALLING LOG AND EMBER SET. 

 

 

 
 
 

1.  Open the two hinged side panels, open the door. 
 
2.  Remove log and ember set and all wrapping material from the 

stove. Check for damage. If damage is observed, do not use 
unit and contact your local dealer. 

 
3.  Remove the two wood screws that secure the stove to the 

pallet, these are located through the square openings inside 
the side panels. 

 
4.  Place the stove on its back on the pallet. Pre-thread the 4 

holes in the base of the stove that secure the pedestal to the 
stove using the 4 screws ( 5/16 hex washer heads) provided.  
Place pedestal so that the holes in the base of the stove align 
with those in the pedestal and tighten screws by hand first. 
Then tighten with a 5/16 socket wrench. 

 
5.  Return the unit to the upright position reinstalls the log set 

and embers as per instructions in section 11. 

 

7