Teledyne powerpod 400 Manual Do Utilizador

 

Page 19 of 42

 

 

10.1.  ENTERING THE SETUP/CAL MODE 

 

 
 
 
 
 
 

 

Pressing the MODE key causes the MODE menu to be displayed.  Choose the SETUP/CAL mode by 
pressing the number “3” key then ENTER.  A CHANNEL SELECT menu is presented on the display.  
It should be noted that, although the user must select a specific channel number, some choices in the 
following menus may affect the operation of all channels and/or the display (ex; Display Brightness, type of 
communication).  See the following menu options for more details. 

10.2.  DISPLAY SETUP 

After entering the SETUP/CAL mode and selecting a channel number as described in the previous 
section, several selections are available that will affect the display.  Follow the steps below to gain the 
desired customized display. 

 

Use the serial command “DndCr”, where 

n = channel number, 
d = 1 for Totalizer Mode, 
      2 for Meter Mode, 
      3 for a blanked line and 
Cr = carriage return. 

 
 
 
 

 
While the SETUP/CAL menu is displayed, choose DISPLAY by pressing the keys “1” + ENTER.  
Choose BRIGHTNESS by pressing the number “1” key + ENTER.  The BRIGHTNESS menu will be 
visible.  One of four different brightness levels can be chosen by pressing a number key.  The number “1” 
key selects the dimmest setting while the number “4” key selects the brightest.  Any change in brightness 
will affect the entire display after pressing the ENTER key. 

10.0  Setup/Cal Mode