3com WX4400 3CRWX440095A Manual Do Utilizador

C

HAPTER

 7: IP S

ERVICES

 C

OMMANDS

Examples — To display NTP information for a WX switch, type the 
following command:

WX4400> display ntp

NTP client: enabled

Current update-interval: 20(secs)

Current time: Fri Feb 06 2004, 12:02:57

Timezone is set to 'PST', offset from UTC is -8:0 hours.

Summertime is enabled.

Last NTP update: Fri Feb 06 2004, 12:02:46

NTP Server          Peer state          Local State

---------------------------------------------------

192.168.1.5         SYSPEER             SYNCED

Table 39 describes the fields in this display.

Table 39   Output for display ntp

NTP client

State of the NTP client. The state can be one of the 
following:

„

Enabled

„

Disabled

Current update-interval Number of seconds between queries sent by the WX to 

the NTP servers for updates.

Current time

System time that was current on the WX when you 
pressed Enter after typing the display ntp command.

Timezone

Time zone configured on the WX switch. MSS offsets the 
time reported by the NTP server based on the time zone.

This field is displayed only if you change the time zone.

Summertime

Summertime period configured on the WX switch. MSS 
offsets the system time +1 hour and returns it to standard 
time for daylight savings time or a similar summertime 
period that you set. 

This field is displayed only if you enable summertime.

Last NTP update

Time when the WX received the most recent update from 
an NTP server.

NTP Server

IP address of the NTP server.