Yamaha 5TE-F8197-10 Manual Do Utilizador
8 - 50
CHAS
REAR SHOCK ABSORBER AND SWINGARM
INSTALLING THE REAR AXLE HOUSING
1.Install:
1.Install:
●
Rear axle housing
●
Final gear case assembly
●
Rear axle
(with dust seal)
(with dust seal)
*****************************************************
Installation steps:
Installation steps:
●
Install the drive shaft.
Refer to “REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT” in CHAPTER 7.
Refer to “REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT” in CHAPTER 7.
●
Apply sealant (Quick Gasket
®
) to the mating
surfaces of the swingarm and the final gear
case.
case.
●
Temporarily install the rear axle housing
1
and final gear case assembly
2 on the
swingarm. The bolts and nuts
3 ~ 5 should
be temporarily tightened.
●
Install the rear axle (with dust seal)
6 from
the left side of the machine.
Refer to “REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT” in CHAPTER 7.
Refer to “REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT” in CHAPTER 7.
●
Tighten the bolts and nuts
3 ~ 5 in the
specified order.
3 Nut (×4)
4 Bolt (×4)
5 Bolt/nut (×4)
*****************************************************
T
R
.
.
Nut
3:
63 Nm (6.3 m • kg, 45 ft • lb)
LOCTITE
LOCTITE
®
Bolt
4:
63 Nm (6.3 m • kg, 45 ft • lb)
LOCTITE
LOCTITE
®
Nut
5:
63 Nm (6.3 m • kg, 45 ft • lb)