Zooper BU820T Folheto

Do not fold your stroller when wet.
Machine wash removable seat and armrest covers using gentle cycle, cold water, 
and a mild  detergent. Do not use bleach. The canopy can only be spot washed.
Do not use dr yer  to dr y fabric parts. 
Do not leave your stroller in direct sunlight for extended periods of time.
Clean and lubricate all moving parts on the stroller frame and wheels as needed. 
Use only a penetrating silicon based lubricant.   
Regularly check for loose screws, broken parts, etc. Use only Zooper approved 
replacement parts available through the service centers listed below. 
Wipe off any sand, salt or other corrosive residue after each use where the stroller 
may be exposed to those elements.

MAINTENANCE

IMPORTANT CARE AND SAFETY INFORMATION

Avoid serious injur y from falling or sliding out, always use safety harness provided.
This stroller is designed for a child six months of age until the child weighs 55 lbs.
This stroller is not suitable for use with newborns.
This stroller is not compatible with any infant car seat carriers.  
Always engage both rear brakes when not holding onto your stroller.
Never leave your child unattended.
Never use the stroller near an open fire or exposed flame.
Never allow the stroller to be used as a toy.
Never allow more than one child at a time in the stroller.
Never hang bags or other items from the handle or on the canopy. This 
may cause the stroller to become unstable.
Never use the stroller on stairs or escalators.
Do not overload the basket. Maximum load is 7 lbs. Excessive weight may 
cause a hazardous unstable condition to exist.
This stroller is not recommended for use with a child over 55 lbs. 
This stroller is designed as a walking stroller. We do not recommend running, 
roller blading, or other such activities with this stroller.
This stroller is a single stroller, do not use any attachments that allow for 
a second child.
It may be unsafe to use accessories other than those approved by the 
manufacturer or distributor.

IMPORTANT: READ THESE SAFETY INSTRUCTIONS CAREFULLY BEFORE USING 
YOUR STROLLER AND KEEP THEM FOR FUTURE REFERENCE. THE SAFETY OF 
YOUR CHILD DEPENDS ON IT.

Thank you for choosing Zooper. 

UNLOCKING & OPENING THE FRAME

We recommend you choose a good floor surface. Your 
Zooper has a strong metal frame that could scratch 
hardwood floors or other sensitive surfaces. To open the 
frame, first pull back on the frame lock which connects 
the rear leg to the handle (Fig. 1). Grasp the handle and 
pull back and up so that the stroller frame opens (Fig. 2). 
Step down on the foot block while pulling back on the 
handle so that the frame snaps open (Fig. 3). 

  Be sure children are at a safe 

distance and cannot reach moving parts whenever 
opening or closing the stroller. Do not open the frame 
by stepping down on the brake lever as this may result 
in damage to your  Zooper. Always step down on the 
foot block to open the  stroller.Always make sure the 
stroller has been opened  fully by checking to see that 
the metal bars connecting the foot block to the frame 
are straight and parallel to the ground.

Line up each front wheel block with the front leg and 
push firmly together (Fig 4). Always check to see that 
the wheels have been properly installed by pulling out 
on the wheel block. It should be locked to the front leg. 
To remove, push in on the looped metal retention clip 
located on the underside of the wheel block, and pull 
the wheel block off.

FRONT WHEEL BLOCKS

REAR WHEELS

To install the rear wheels, line up each wheel block 
with each rear leg tube (Fig. 5). The brake levers must 
be facing out, away from the stroller. Locate the 
spring lock buttons on the outside of the rear leg 
tubes. Make sure the buttons are coming out of the 
button holes and have not slipped inside the tube 
during shipping. If you are missing a spring lock, 
please contact the appropriate service center listed 
at the back of these instructions for replacement 
parts. Push the rear wheel block onto the rear frame 
leg until it clicks onto the spring lock button. Then 
repeat for the other wheel block. Check visually that 
the buttons have popped out of the small holes on 
the outside of the wheel assembly. Pull out on each 
wheel black to make sure that it has locked into 
place.

Twist  BU820X/T

Fig.2

Fig.4

Do not use this stroller if the 

buttons do not  properly pop out and lock the rear 
wheels in place. Contact the appropriate service 
center listed at the back of these instructions for 
replacement parts.

Fig.5

ATTACHING THE CANOPY

To attach the canopy, insert the plastic shafts into 
the plastic slots located on the outside of the main 
stroller tubes (Fig 10). They are inserted from the 
bottom up.Lift up to check that each side is locked 
into position. Open the canopy by pushing down on 
the plastic side canopy braces. Be sure to snap the 
canopy to the seat and backrest fabric whenever 
the seat is fully reclined. Retract the canopy by first 
pulling up on the side braces, then pushing the 
canopy hood back. The canopy can be converted 
to allow more air flow through the stroller. Unzip the 
lower half of the canopy from the upper half. This will 
leave a mesh cover that can snap to the back of the 
seat. The canopy may also be used as a napper 
canopy. Locate the zipper on the rear rib of the 
canopy. When unzipped, the canopy will fall forward 
over the bumper bar, completely shading baby from 
the world. To remove the canopy, first undo the 
snaps. Then pull the release tabs outward and slide 
the canopy down, off the slots. 

Do not tr y to retract the canopy 

when the side canopy braces are fully open or with 
the sun visor extended. This may damage the 
canopy. 

To recline the backrest, push down simultaneously on 
the backrest tabs located on either side of the stroller 
(Fig. 7). Move the seat into desired position. To raise 
the backrest, simply push up on the back of the seat 
until it is in the desired position. 

Always keep your child in sight 

when making these kinds of adjustments. Check the 
fitting of  the safety harness each time the backrest is 
adjusted to  be sure a snug, yet comfortable fitting is 
maintained.

ADJUSTING THE SEATBACK

Fig.7

SAFETY HARNESS

Zooper provides a special 5-point harness safety 
system. Used properly, this harness will keep your child 
seated and safe. To secure your child in the harness, 
push buckles (A) and (B) into the buckle housing (C) 
until the buckle prongs snap into position. Carefully 
adjust slider (D) to fit snugly and comfortably around 
your child (Fig 8). Follow the same procedure to 
adjust the shoulder straps. Always retighten the 
harness when your child is in a sit up or layback 
position.

      WARNING:

Avoid serious injur y or death from 

falling or sliding out. ALWAYS use the seat belt. NEVER 
leave your child unattended.

LEG REST

To lower the leg rest, push up on the lever located on 
the underside of the seat (Fig 9). Move into  the  down 
position. To raise, simply push up on the leg rest. 

      WARNING:

 Never allow your child to sit on 

the leg rest. This may result in injur y to your child 
and/or damage to your Zooper. Children should 
always be properly seated with the safety harness 

Fig.9

USING THE BRAKES

To engage the brakes, step down on break lever, 
(Fig.10). The brake lever should be facing out. Always 
check that the brakes have fully engaged by pushing 
forward on the stroller to make sure it stays in place. 
Lift the brake lever with your foot to release the brakes. 

      WARNING:

  Always engage the  brakes when 

you are not holding onto the stroller and check  that  
The brakes have been properly engaged as described 
above. Always engage the brakes when putting your 
child in, or taking your child out, of the stroller.

Fig.10

SWIVEL WHEELS

The swivel-locking lever is located on the back of the 
front wheel block where it meets the frame (Fig. 11). 
Push the lever up to allow the front wheels to swivel. To 
lock the wheels into a fixed position, push down on 
the locking lever and move the stroller forward. The 
wheels will lock automatically. The wheels should be 
locked in the fixed position when walking over uneven 
surfaces.

Fig.11

CLOSING THE STROLLER FOR 
TRAVEL OR STORAGE

Each time, before closing your stroller, check the 
following:
    Your child is clear of moving parts
    The rear brakes have been set
    The backrest is in the full, upright position
    The front wheels are secure in the locked mode
    The canopy is retracted
    All items have been removed from the basket
    Never attempt to fold or close your Zooper with your
    Child inside

First release the primar y lock by lifting the foot block 
up with your foot (Fig 12). Then lift up on the secondar y 
lock tab, just above the foot block, to release the 
frame . Push the handles forward and collapse the 
stroller down into the folded position(Fig 13)  Attach 
the frame lock(Fig 14).

Fig.13

Fig.1

Fig.6

Shoulders

Straps

Fig.8

Fig.12

Fig.14

Fig.3