Uniden UBW2101 Manual Do Utilizador

This device complies with Part 15 of the FCC Rules. Operation is subjected to the 

following two conditions: (1) this device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that 

may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class 

B digital device, pursuant to Part 15 of the FCC rules and ETSI (EN) 300328. 

These limits are designed to provide reasonable protection against harmful 

interference in residential installations. This equipment generates, uses, and can 

radiate radio frequency energy, and if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause interference to radio or television 

equipment reception, which can be determined by turning the equipment off and 

on, the user is encouraged to try to correct the interference by one or more of the 

following measures:

 x Reorient or relocate the receiving antenna.
 x Move the equipment away from the receiver.
 x Plug the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

 x Consult the dealer or an experienced radio/television technician for additional 

suggestions.

The antenna used for this transmitter must be installed to provide a separation 

distance of at least 20 cm (7.9”) from all persons and must not be collocated or 

operating in conjunction with any other antenna or transmitter. 

The term “IC:” before the radio certification number only signifies that Industry 

Canada technical specifications were met. Operation is subject to the following 

two conditions: (1) this device may not cause interference, and (2) this device 

must accept any interference, including interference that may cause undesired 

operation of the device. “Privacy of communications may not be ensured when 

using this device”.

Products with CE Marking comply with EMC Directive (2004/108/EC); low voltage 

Directive (73/23/EEC); R&TTE(1999/5/EC) issued by the Commission of the 

European Community. Compliance with these directives implies conformity to the 

following European Norms:

 x EMC: EN 301 489
 x LVD: EN 60950
 x Radio: EN 300 328