Renesas R5S72621 Manual Do Utilizador
Section 21 IEBus
TM
Controller
Page 1094 of 2108
R01UH0134EJ0400 Rev. 4.00
Sep
24,
2014
SH7262 Group, SH7264 Group
(7) Parity bit
The parity bit is used to confirm that transfer data occurs with no errors.
The parity bit is added to respective data of the master address, slave address, control, message
length, and data bits.
length, and data bits.
Even parity is used. When the number of bits having the value 1 is odd, the parity bit is 1. When
the number of bits having the value 1 is even, the parity bit is 0.
the number of bits having the value 1 is even, the parity bit is 0.
(8) Acknowledge bit
In normal communications (single unit to single unit communications), the acknowledge bit is
added in the following positions to confirm that data is correctly accepted.
added in the following positions to confirm that data is correctly accepted.
At the end of the slave address field
At the end of the control field
At the end of the message length field
At the end of the data field
The acknowledge bit is defined below.
At the end of the control field
At the end of the message length field
At the end of the data field
The acknowledge bit is defined below.
0: indicates that the transfer data is acknowledged. (ACK)
1: indicates that the transfer data is not acknowledged. (NAK)
Note that the acknowledge bit is ignored in the case of broadcast communications.
1: indicates that the transfer data is not acknowledged. (NAK)
Note that the acknowledge bit is ignored in the case of broadcast communications.
(a) Acknowledge bit at the End of the Slave Address Field
The acknowledge bit at the end of the slave address field becomes NAK in the following cases and
transfer is stopped.
transfer is stopped.
When the parity of the master address or slave address bits is incorrect
When a timing error (an error in bit format) occurs
When there is no slave unit
When a timing error (an error in bit format) occurs
When there is no slave unit