Pioneer VSX-AX5i-G Manual Do Utilizador

En

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong 
with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the 
other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the 
checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.

• An output signal is not produced from 

the i.LINK connector on the source 
player.

• The selected component is not compati-

ble with i.LINK Audio.

• The selected component does not corre-

spond to DTCP.

• Refer to the manual that came with the 

source player.

• Refer to the manual that came with the 

source player.

• The unit corresponds to DTCP. Refer to 

the manual for the selected compo-
nent.

• The i.LINK cable is dislocated.
• The i.LINK cable is too long.
• The selected component does not corre-

spond to the i.LINK AUDIO format.

• The component between the unit and 

the source player is turned off.

• Check all connections.
• Use a cable less than 3.5m long.
• Refer to the manual for the selected 

component.

• When the source player is turned off or 

in the standby mode, the output signal 
is not produced. Refer to the manual 
for the selected component.

• The program format indicators remain lit 

until another format source is input.

• During playback through an i.LINK con-

nection, if you change the settings for 
other i.LINK components, the sound will 
be discontinued momentarily.

• Depending on the upgrade process, cer-

tain components may not be recognized 
by the unit.

• Initialized all the information stored in 

the unit in the order as follows:
1. When the unit is in the standby 
mode, press and hold STEREO/DIRECT 
and then press STANDBY/ON.
2. When “DB CLEAR?” is displayed, 
press MULTI CH IN.
3. When “DB CLEAR OK?” is displayed, 
press ACOUSTIC EQ.
4. Make sure “DB CLEAR SET” is 
displayed to end initialization.
5. If “DB ERROR” is displayed, step 
through the procedure again.

• The power plug is disconnected.

• The protection circuit may have been 

activated.

• Connect the power plug to the wall out-

let.

• Disconnect the power plug from the 

outlet, and insert again.

VSX-AX5i.book  Page 109  Friday, May 23, 2003  6:33 PM