3com 2200 Manual Do Utilizador

C

HAPTER

 11: A

DMINISTERING

 B

RIDGE

 P

ORTS

4 Enter the new multicast threshold value for the port(s).

See the example below:

Ethernet port 4 - Enter new value [0]: 

Ethernet port 5 - Enter new value [0]: 

You can enable or disable the Spanning Tree Protocol for one or more ports 
on the system. This only affects the operation of the port if the Spanning 
Tree Protocol is enabled. You can also set the following STP port parameters: 
path cost and priority. For more information about how Spanning Tree 
parameters interact at the bridge-port level, see Chapter 5: Transparent 
Bridging in the SuperStack™ II Switch 2200 Operation Guide.

You can enable and disable the Spanning Tree Protocol for any port in the 
system. When STP is disabled for a port but enabled for the entire bridge, a 
port does not forward frames or participate in the Spanning Tree algorithm. 
(See page 10-7 for instructions on enabling STP for the entire bridge.) 
When STP is disabled for a port as well as for the entire bridge, the port will 
continue to forward frames. 

By default the Spanning Tree state value on a port is the same as the 
Spanning Tree state value set for the bridge.

To enable or disable STP on a port:

1 From the top level of the Administration Console, enter:

You are prompted for the port type.

2 Enter 

, 

, or 

.

You are prompted for the port number(s).

3 Enter the number(s) of the port(s) or 

 to enable or disable all ports for 

the Spanning Tree Protocol. 

You are prompted for a new value for each port you specified.

4 Enter 

 or 

 at the prompts.

system
ethernet
fddi

➧

bridge
ip
snmp
analyzer
script
logout

display
ipFragmentation
ipxSnapTranslation
addressThreshold
agingTime
stpState
stpPriority
stpMaxAge
stpHelloTime
stpForwardDelay
stpGroupAddress

➧

port
packetFilter

summary
detail
multicastLimit

➧

stpState
stpCost
stpPriority
address