Jenn-Air JMC2430WS Manual Do Utilizador

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

A UL listed or CSA approved conduit connector

■

UL listed wire connectors

■

6 screws

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”

It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

IMPORTANT: Observe all governing codes and ordinances. 

■

Cabinet opening dimensions that are shown must be used. 
Given dimensions provide minimum clearance with 
microwave oven.

■

Recessed installation area must provide complete enclosure 
around the recessed portion of the microwave oven. 

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

■

Electrical supply junction box should be located 3" (7.6 cm) 
maximum below the support surface when the microwave 
oven is installed in a wall cabinet. A 1¼" (3.4 cm) minimum 
diameter hole should have been drilled in the left rear corner 
of the support surface to pass the appliance cable through to 
the junction box.

■

If you are installing the junction box on rear wall behind the 
microwave oven, the junction box must be recessed and 
located in the upper or lower right or left corner of the 
cabinet; otherwise, the microwave oven will not fit into the 
cabinet opening.

■

Microwave oven support surface must be solid, level and 
flush with bottom of cabinet cutout. Floor must be able to 
support a weight of 90 lbs (41.0 kg).

IMPORTANT: To avoid damage to your cabinets, check with your 
builder or cabinet supplier to make sure that the materials used 
will not discolor, delaminate or sustain other damage. This oven 
has been designed in accordance with the requirements of UL 
and CSA International and complies with the maximum allowable 
wood cabinet temperatures of 194°F (90°C).

■

Phillips screwdriver

■

Flat-blade screwdriver

■

Measuring tape

■

Level

■

Drill (for wall cabinet installations)

■

¹⁄₈" (0.32 cm) drill bit (for wall 
cabinet installations)

¹⁄₈

³⁄₄

⁷⁄₁₆

¹⁄₈

³⁄₄

⁷⁄₁₆

A

E

C

B

D