Honeywell MS-9600LSC Manual Do Utilizador

MS-9600LS Series Manual — P/N 52646:B2  2/12/2010

29

Product Description



The following steps can be used as a guide to wire the annunciator.  Make certain all power has 
been removed from the FACP prior to annunciator installation.

1. Route wires from hole in backplate, through wiring channel and then to ANN-80 terminal 

block TB1. 

2. Remove appropriate amount of wire insulation. 
3. Connect the wiring from the FACP ANN-BUS to annunciator TB1 terminals 3 (A) & 4 (B).  

Make certain to connect A to A and B to B.

4. If appropriate, connect the wiring going to the next device on the ANN-BUS to TB1 terminals 

3 & 4.  Make certain to connect A to A and B to B. 

5. Connect the wiring from the 24 VDC power source to annunciator TB1 terminals 1 (-) & 2 (+).  

Make certain to observe proper polarity.

6. If appropriate, connect the power wiring going to the next device to terminals 

1 (-) & 2 (+).  Make certain to observe proper polarity. 

7. After all connections are made, remove extra wire from inside of annunciator by dressing it 

neatly through wire channel, with any excess wire pushed back through hole into electrical 
box.

wiring channel

wires

an

n-

80

bo

xi

n

side

.wmf

B  A   (+)  (-)

4    3    2    1

+ - + - + -

A B

+ -

FACP

ANN-80

ANN-BUS and power wiring are 

supervised and power-limited

24 VDC
nonresettable

ANN-BUS

960

0

ls

to

an

n80

.cd

r

ANN-BUS/
ACS BUS