Honeywell MS-9600LSC Manual Do Utilizador

MS-9600LS Series Manual — P/N 52646:B2  2/12/2010

69

Programming



The programmer can change a detectors existing or factory default programming by pressing 3 in 
the Detector Screen.  The following screen will be displayed: 

A flashing cursor will appear in the position of the first asterisk to the left.  The programmer keys in 
the three digit detector address, such as 017.  

When the last digit is keyed-in, if the selected address has not been added to programming, a screen 
showing information about a device that is installed with a lower address, closest to the selected 
address, will be displayed.

If no detectors have been installed on the loop, the following will be displayed: 

If the selected address has been added to programming, device summary screens will be displayed.  
These screens allow the programmer to view all device settings at a single glance.  Pressing the left 
or right arrow keys will allow the programmer to rapidly view the devices at the previous or next 
address (if installed).

If a detector (such as a photoelectric detector) with the selected address is not physically installed 
on the SLC or has a communication fault but the address is programmed in the system, the follow-
ing screen will be displayed: 

  EDIT DETECTOR

ENTER POINT ADDRESS

***

    NO DETECTOR

     INSTALLED

 TROUBL SMOKE(PHOTO)

 ********************

               ZNNN

           *   1D017