Enviro 1200 Fireplace Freestanding Manual Do Utilizador

Installation

1.  If the surround panel is installed, remove it by lifting the panel straight 

up then out.

2.  For the right shroud, twist the handle on the air control clockwise to 

remove it from the rod.

3.  Pull unit forward a few inches, if possible.
4.  Remove the screw, using a 

5

/

16

” socket or wrench, that goes down 

through the firebox top into a bent over tab at the top of the shroud 

(see A in Figure 51). 

5.  The shrouds can be  removed one of two ways:

a.  For the first method, pull the inside edge of the shroud straight 

out, approximately 3⁄4” (2cm), in order to unhook the shroud from 

unit. Pull the shroud out through the side. 

b.  For  the  second  method  (recommended  for  the  right  shroud), 

remove the two (2) T-20 screws that hold the shroud to the unit 

(see B in Figure 51). Pull the shroud out through the side. 

6.  To install the shroud, follow steps 1 through 5 in reverse order. Ensure 

the shrouds are hooked behind both screws on either side.

Vibration

Bumper

1.  Remove  the  shroud  from  the  unit  (refer  to  “R

EMOVAL

  O

F

  T

HE

  S

HROUDS

  - 

I

NSERT

”)

2.  Remove the fan from the left shroud (refer to ”F

AN

 R

EMOVAL

 - I

NSERT

”)

3.  Unfasten the two (2) nuts that secure the plate to the shroud. The nuts 

should only be hand-tightened but a 

5

/

16

” wrench may be required.

4.  Remove the old plate from the shroud and remove the vibration bumper 

from the plate. Leave the washers on the shroud.

5.  Install  the  vibration  bumper  into  the  new  decorative  plate  and  install 

new plate onto the shroud.

6.  Hand-tighten the two (2) nuts back into place.
7.  Re-install the fan into the left shroud.
8.  Re-install the shrouds onto the unit.

Note:  The  left  decorative  plate  has  rectanglular  holes  and  the  right  

decorative plate does not.

40