Honeywell C7023J Manual Do Utilizador

63-2590—05

10

The C7031D Sensor includes an immersion well. The C7021D, 

C7023D, and C7041D sensors do not include a well. For the 

C7021D, C7023D, and C7041D, order the well as an 

accessory (part no.: 50001774-001).

When used on a boiler, follow the manufacturer instructions for 

location. If a tapped hole is not provided for the immersion well, 

provide one as follows:

1. Drain boiler and drill a 23/32 in. (18 mm) hole at the 

selected location.

2. Cut threads in the hole with a 1/2 in. (13 mm) by 14 NPT 

tap.

In other installations, mount the immersion well in an elbow 

with a heel outlet as shown in Fig. 15.

1. Drain the system, if you have not already done it, and 

open the tapped hole.

2. Put pipe joint compound on the threads of the 

immersion well and screw it into the tapped hole or 

elbow, tightening it securely.

3. Refill the system and check for leaks.

Mount the C7021D, C7023D, C7031D and C7041D into the 

well:

NOTE: Mounting using previously installed Honeywell 

wells (part no.: 32005960-001) requires an 

adapter (part no.: 50001775-001).

1. When an adapter is required, first thread it into the well 

no more than one or two turns.

2. Slide the sensor into the well.

3. Rotate the sensor to thread it tightly into the adapter and 

the adapter tightly into the well.

Strap-on mounting is well-suited for retrofit applications where 

installation costs can be reduced by not draining the system. 

The C7021K, C7023K, C7041K Sensor mounts on metal pipes 

from 1-5/8 inch to five inches in diameter using the straps 

supplied. Clean the surface of the pipe where the sensor 

makes contact before mounting (remove insulation from the 

pipe at the point of installation if necessary). Thermal 

compound is recommended with the strap-on C7021K, 

C7023K, C7041K Sensor. Locate the sensor on the discharge 

pipe within 3 feet (0.9m) of the boiler. See Fig. 16.

NOTE: Insulation around the contact area increases sensor 

accuracy.

The C7021P, C7023P, C7041P Button Probe Sensor design 

simplifies mounting into a variety of standard structural 

materials.

The locking nut can be used to secure the probe. See Fig. 18.

The plastic spacer helps insulate the probe from drywall, wood, 

or other material in which the probe is mounted. The spacer is 

sized to fit snugly into 1/2 in. metal conduit. See Fig. 17.

NOTES:

—

The plastic spacer is threaded for easy installation.

—

Use of both the locking nut and spacer requires 

cutting spacer to shorter length.

C7041P MOUNTING RECOMMENDATIONS
Determine the proper location based upon the following:

— Mount the probe to an inside wall approximately 54 in. 

(1372 mm) from the floor (or in the specified location) to 

allow exposure to the average zone temperature.

— Do not mount the probe to an outside wall, a wall containing 

waterpipes, or near air ducts.

— Avoid locations exposed to register discharge air, or 

radiation from lights, appliances, or the sun.

1/2 NPT (13)

M22135

SENSING ELEMENT

(SEALED IN STAINLESS STEEL 

TUBE INSIDE OF INSERTION WELL)

M22136

SENSOR

PIPE

COPPER PLATE MUST

MAKE GOOD CONTACT

WITH METAL PIPE

WORM GEAR

M22797