ONKYO PR-155X Manual Do Utilizador

 

12

1

2

3

1 Detach the battery cover.
2 Insert two size-AA/R6 batteries.

Be sure to match the + and – ends of the batteries with to diagram inside the battery
compartment.

3 Attach the battery cover.

• Do not mix new batteries with old batteries or different kinds of batteries.
• To avoid corrosion, remove the batteries if you do not intend to use the remote controller

for a long time.

• Remove dead batteries immediately to avoid damage from corrosion. If the remote con-

troller does not operate smoothly, replace both batteries at the same time.

• The batteries should last for about six months, although this will vary with usage.

DV-S155X

RC-522DV

30˚

30˚

DV-S155X

30˚

30˚

Remote control sensor

About 5 m (16 f

eet)

Point the remote controller toward the remote control sensor.

• Place the unit away from strong light, such as direct sunlight or inverted fluorescent light,

which can prevent proper operation of the remote controller.

• Using another remote controller of the same type in the same room or using the unit near

equipment that uses infrared rays may cause operational interference.

• Do not put any object (such as a book) on the remote controller. The buttons of the remote

controller may be pressed by mistake, which drains the batteries.

• Make sure the audio rack doors do not have colored glass. Placing the unit behind such

doors may prevent proper remote controller operation.

• If there is an obstacle between the remote controller and the remote control sensor, the

remote controller will not operate.

Amplifier

(PR-155X, etc.)

RC-568S

About 5 m (16 f

eet)

Remote control sensor

DV-S155X-En.book Page 12 Saturday, July 24, 2004 2:20 PM