Lennox International Inc. Merit Series Air Conditioner Manual Do Utilizador
7/2012
506945-01
*2P72012*
*P506945-01*
Page 1
E2013 Lennox Industries Inc.
Dallas, Texas, USA
THIS MANUAL MUST BE LEFT WITH THE
HOMEOWNER FOR FUTURE REFERENCE
WARNING
The State of California has determined that this product
may contain or produce a chemical or chemicals, in very
low doses, which may cause serious illness or death. It
may also cause cancer, birth defects, or reproductive
harm.
may contain or produce a chemical or chemicals, in very
low doses, which may cause serious illness or death. It
may also cause cancer, birth defects, or reproductive
harm.
GENERAL
This 13ACX outdoor unit is designed for use with HFC-410A
refrigerant only. This unit must be installed with an approved
indoor unit. See the Lennox 13ACX Product Specifications
bulletin (EHB) for approved indoor component match ups.
refrigerant only. This unit must be installed with an approved
indoor unit. See the Lennox 13ACX Product Specifications
bulletin (EHB) for approved indoor component match ups.
These instructions are intended as a general guide and do
not supersede local codes in any way. Consult authorities
having jurisdiction before installation.
not supersede local codes in any way. Consult authorities
having jurisdiction before installation.
INSTALLATION
INSTRUCTIONS
INSTRUCTIONS
Merit
®
Series 13ACX
Units
AIR CONDITIONER
506945-01
5/2013
Supersedes 7/2012
506945-01
5/2013
Supersedes 7/2012
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause personal injury, loss of life, or
damage to property.
maintenance can cause personal injury, loss of life, or
damage to property.
Installation and service must be performed by a licensed
professional installer (or equivalent) or a service agency.
professional installer (or equivalent) or a service agency.
CAUTION
Before attempting to perform any service or maintenance,
turn the electrical power to unit OFF at disconnect switch.
turn the electrical power to unit OFF at disconnect switch.
CAUTION
As with any mechanical equipment, contact with sharp
sheet metal edges can result in personal injury. Take care
while handling this equipment.
sheet metal edges can result in personal injury. Take care
while handling this equipment.
STEP 1 -- SETTING THE UNIT -- Clearances
6 (152)
36 (914)
12 (305)
30 (762)
LINE SET
CONNECTIONS
CONNECTIONS
24 (610)
LINE SET
CONNECTIONS
ACCESS
PANEL
48 (1219)
MINIMUM CLEARANCE BETWEEN TWO UNITS
CLEARANCE ON ALL SIDES — INCHES (MILLIMETERS)
MINIMUM CLEARANCE
ABOVE UNIT
NOTES:
S
Clearance to one of the other three
sides must be 36 inches (914mm).
sides must be 36 inches (914mm).
S
Clearance to one of the remaining
two sides may be 12 inches
(305mm) and the final side may be
6 inches (152mm).
two sides may be 12 inches
(305mm) and the final side may be
6 inches (152mm).
FIGURE 1
Litho U.S.A.