Desa (V)DVF36TCRP(E) Manual Do Utilizador

www.desatech.com

112108-01C

26

3. If replacement is necessary, the entire assem-

bly (frame and glass) must be replaced. If glass

is broken, wear gloves and tape remaining

fragments onto the frame. Remove 5 screws

located on end of firebox while holding frame

assembly to prevent it from falling and caus-

ing injury (see Figure 54). Mount new frame

at hinge with 5 new screws. Close and latch

door. This will seat the gasket. If replacing end

glass panel, remove 16 screws around frame

(see Figure 55) To insure proper fit, when

installing new glass panels make sure seam

in gasket is placed in the down position.

4. Replace screen assembly and top and bottom

louvers.

CLEANING AND

MAINTENANCE

Continued

Figure 54 - Removing Glass Door

Figure 55 - End Panel Replacement

Glass
Assembly

Frame
Assembly

Louver Assembly

Retainer Screws

Screws

Hinge

OPERATING FIREPLACE

MILLIVOLT

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BeFore LiGhTiNG smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WhAT To Do iF YoU SMeLL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• immediately call your gas supplier from

a neighbor’s phone. Follow the gas

supplier’s instructions.

• if you cannot reach your gas supplier, call

the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. if the

knob will not push in or turn by hand, don’t

try to repair it, call a qualified service tech-

nician or gas supplier. Force or attempted

repair may result in a fire or explosion.

D. Do not use this appliance if any part has

been under water. immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

LIGHTING

INSTRUCTIONS

1. SToP! read the safety information begin-

ning above before proceeding.

2. Set the hi-Lo knob to the lowest setting.

3. Turn off all electrical power to the appliance.

4. open control access panel.

5. Push in gas control knob slightly and turn

clockwise

to oFF.