Philips PPX4350/INT Manual Do Utilizador
Service
21
Troubleshooting
Power Cycling
If a problem occurs that cannot be corrected with the
instructions in this user manual (see also the help
below), follow the steps given here.
instructions in this user manual (see also the help
below), follow the steps given here.
1 Switch the device off using the on/off switch on the
side.
2 Wait at least ten seconds.
3 Switch the device on using the on/off switch on the
side.
4 If the problem repeats, please contact our technical
customer service or your retailer.
Problems
Solutions
The Pocket Projector cannot be switched on
•
Connect the supplied power supply to recharge the
internal battery.
internal battery.
No sound
•
Check the sound level in the menu Extras / Sound
settings / Volume menu, adjust the volume with the
À/Á// key.
settings / Volume menu, adjust the volume with the
À/Á// key.
No sound from the external connected device
•
Check the cables to the external device
•
Set the volume on the external device
•
Only the original cables from the device manufac-
turer may function
turer may function
Bad sound quality with your computer connection
•
Check if the audio cable is connected to the comput-
ers headphone socket or the line-out socket.
ers headphone socket or the line-out socket.
•
The volume setting on the computer should not be
too high.
too high.
Only the initial screen appears and not the image from
the external device
the external device
•
Check if the cables are connected to the right sock-
ets.
ets.
•
Please check that the external device is switched on
•
Check if the video output of the external device is
switched on.
switched on.
Only the initial screen appears and not the image from
the connected computer
the connected computer
•
Please make sure the HDMI cable can work nor-
mally.
mally.
•
Check that HDMI cable is correctly connect to com-
puter's HDMI interface.
puter's HDMI interface.
•
Check if the resolution of the computer is set to
640x360.
640x360.
Device switches turns off
•
When the device is running for a long period of time,
the surface becomes hot and a warning symbol
appears on the projection, see also symbols in the
status bar. The device automatically turns off when it
gets too hot. After the device has cooled down, you
can continue playback.
the surface becomes hot and a warning symbol
appears on the projection, see also symbols in the
status bar. The device automatically turns off when it
gets too hot. After the device has cooled down, you
can continue playback.
•
When the battery does not have sufficient capacity,
the device turns off. Connect the device to the
power supply.
the device turns off. Connect the device to the
power supply.
The device is connected to the power supply and
switches to stand-by mode
switches to stand-by mode
•
The battery is in deep discharge. The device can be
turned on and is ready to use after approximately
five minutes of charging time (see also Battery deep
discharge, page 18).
turned on and is ready to use after approximately
five minutes of charging time (see also Battery deep
discharge, page 18).
PPX4350_UM_EN_253624544.book Page 21 Jeudi, 29. janvier 2015 11:35 11