Philips DVP3250K/55 Manual Do Utilizador

41

–  Press STANDBY-ON on the unit to turn on the 

power.

–  Ensure that the AC outlet has power.
–  Disconnect the power cord from the power outlet 

for a few minutes. Reconnect the power cord and try 
to operate again as usual.

–  Refer to your TV manual for correct Video In channel  

selection. Change the TV channel until you see the 
DVD screen.

–  If this happens when you turn on the progressive scan 

feature, wait for 15 seconds for the auto recovery or 
switch back to the default mode as below:

1) Press ç to open the disc tray.
2) Press and hold numeric keypad ‘1’ on the remote 

control. 

–  If this happens after you set the color system, wait for 

15 seconds for the auto recovery or switch back to 
the default TV color system:

1) Press ç to open the disc tray.
2) Press and hold numeric keypad ‘3’ on the remote 

control. 

–  Check the video connection.
–  Ensure that the disc is compatible with this unit.
–  Sometimes a small amount of picture distortion may  

 appear. This is not a malfunction.

–  The disc is dirty. Clean the disc.

–  Check the audio connections to the connected audio 

device.  

–  Make sure that the connected audio device is turned 

on to the correct input source.

–  Set the digital output setting correctly, based on the 

device you connected to this unit. See ‘Audio Setup 
Page - Digital Audio Setup’ for details.

WARNING
Under no circumstances should you try to repair this unit yourself, as this invalidates the 
warranty. Do not open this unit as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking this unit for repair. If you 
are unable to remedy a problem by following these hints, consult your dealer or Philips for 
help.

dvp3254K_55_eng4.indd   41

10/31/2008   11:30:20 AM