Philips DVP2008/93 Manual Do Utilizador

36

–  Press 2 on the unit to turn on the power.
–  Ensure that the AC outlet have power.
–  Disconnect the power cord from the power outlet 

for a few minutes. Reconnect the power cord and try 
to operate again as usual.

–  Refer to your TV manual for correct Video In channel  

selection. Change the TV channel until you see the 
DVD screen.

–  If this happens when you turn on the progressive scan 

feature, wait for 15 seconds for the auto recovery or 
switch back to the default mode as below:

1) Press ç  on  this  unit.
2) Press and hold numeric keypad ‘1’ on the remote 

control. 

–  If this happens after you set the colour system, wait 

for 15 seconds for the auto recovery or switch back 
to the default TV colour system:

1) Press ç  on  this  unit.
2) Press and hold numeric keypad ‘3’ on the remote 

control. 

–  Check the video connection.
–  Ensure that the disc is compatible with this unit.
–  Sometimes a small amount of picture distortion may  

 appear. This is not a malfunction.

–  The disc is dirty. Clean the disc.

WARNING
Under no circumstances should you try to repair this unit yourself, as this invalidate the 
warranty. Do not open this unit as there is a risk of electric shock.

If a fault occurs, fi rst check the points listed below before taking this unit for repair. If you 
are unable to remedy a problem by following these hints, consult your dealer or Philips for 
help.

1_dvp1120-2008_93_eng1_final813.36   36

1_dvp1120-2008_93_eng1_final813.36   36

2008-03-24   2:43:18 PM

2008-03-24   2:43:18 PM