Ariens 911094 - Pro 21SCH Manual Do Utilizador

GB - 12

To change front wheel cutting height, insert 
height adjuster pin into the holes that match 
the desired cutting height and fasten with key 
ring (Figure 7).

To change rear wheel cutting height, move 
cutting height levers one notch at a time to 
set the desired cutting height.

Push the primer bulb in to add fuel for easier 
engine start.

The throttle controls the 
engine speed and chokes 
engine for starting.

1.Start - Push lever all the way 

forward.

2.Fast.
3.Slow - Pull lever all the way 

rearward.

Speed control rod changes the mower’s 
forward travel speeds.

High –Push rod all the way 
forward.

Low –Pull rod all the way 
rearward.

Start mowing slowly and use speed control 
rod to gradually increase speed to a safe, 
comfortable walking pace.

Speed control rod should hold the desired 
speed. If not, adjust speed control bell crank. 
(See Speed Control Bell Crank  (self-
propelled models) on page 20.)

NOTE: Engine must be running for wheel 
drive to propel unit.
To drive forward:

Slowly squeeze and hold wheel drive control 
against handlebar.
To stop:

Release wheel drive control.

Figure 7

1. Cutting Height Lever
2. Height Adjuster Pin
3. Key Ring

1

2

3

Rear

Front

High

Low

OM1270

1

2

3

OL2074

CAUTION: Unit will move forward 
at engine start if wheel drive 
control is engaged. ALWAYS 
release wheel drive control before 
starting unit.

OM0480

STOP

GO

OM1240