Jotul GF 100 DV II Manual Do Utilizador

GF 100 DV II Nordic QT
GF 200 DV II Lillehammer

MANUAL

AUTO

OFF

BLOWER

Optional Blower # 155631

Installation

1. Unpack and check the con-

tents of the blower kit. Con-
tact your dealer if any damage
is evident or parts are missing.
See fig. 35.

2. Attach the Control Box to the

Snapstat Bracket using two
#8 x 1/2” sheet metal screws.
As shown in fig. 35, use the
pair of mounting holes appro-
priate for your stove.

3. Attach the Control Box to the

studs located underneath the
stove in the middle of the
firebox floor using the two M6
hex nuts and a 10 mm socket
driver or wrench. See fig. 36.

CONNECT THE GAS SUPPLY TO THE

STOVE BEFORE INSTALLING THIS

BLOWER. USE A 90° ELBOW OFF THE

GAS VALVE TO CREATE ADEQUATE

GAS LINE CLEARANCE.

THIS BLOWER MUST BE

ELECTRICALLY GROUNDED IN

ACCORDANCE WITH LOCAL CODES

OR, IN THE ABSENCE OF LOCAL

CODES, WITH THE CURRENT ANSI/

NFPA 70, NATIONAL ELECTRICAL

CODE OR CSA C22.1-CANADIAN

ELECTRICAL CODE.

THIS UNIT IS SUPPLIED WITH A

THREE-PRONG (GROUNDING) PLUG

FOR PROTECTION AGAINST SHOCK

HAZARD AND SHOULD BE PLUGGED

DIRECTLY INTO A PROPERLY

GROUNDED THREE-PRONG

RECEPTACLE. DO NOT CUT OR

REMOVE THE GROUNDING PRONG

FROM THE PLUG.

ALWAYS DISCONNECT THE POWER

SUPPLY WHEN PERFORMING ANY

SERVICE ON THE FIREPLACE INSERT.

Contents
1. Blower
2. Snapstat Wire Harness
3. Control Box
4. Snapstat Bracket
5. Rheostat Knob
6. Snapstat
7. Mounting Bracket (GF100 DV II ONLY)
8. M6 Flange Nuts, (2)
9. M6 x 12 Hex Bolts, (2)
10. #8 x 1/2” Sheet metal screw, (4)

Tools Required
• 1/4” socket driver
• 10 mm socket
driver or wrench

Figure 36. Attach Control Switch Box.

Secure with

two Hex Head

Flange Nuts

Snapstat

Figure 35. Blower Kit Components

Upper Holes

for GF100

DV II

Lower Holes

for GF200

DV II